Gutter Questions, Answered

New seamless aluminum gutters in San Antonio typically cost $7–$12 per linear foot for 5-inch and $9–$15 for 6-inch, installed. Most single-story homes fall between $1,300 and $2,600, and two-story homes between $2,000 and $4,000. Downspouts, removal of old gutters, gutter guards and underground drains are priced separately so you can choose what you need.

Yes, for most homes. Seamless gutters are formed in one continuous piece per run, so the only joints are at corners and end caps. Fewer joints means fewer leaks and less maintenance than sectional gutters, which are joined every 10 to 20 feet. The price difference is small compared with the years of fewer repairs.

Not always, but they are worth considering. Six-inch gutters make sense for two-story homes, large or steep roofs, roofs with valleys that funnel water into one corner, and lots with heavy oak or pecan debris. For an average single-story home, a well-pitched 5-inch system with enough downspouts usually handles local storms.

Seamless aluminum gutters typically cost $7–$12 per linear foot for 5-inch and $9–$15 for 6-inch, installed. A single-story home of about 2,000 sq ft generally lands between $1,300 and $2,600, and a two-story home between $2,000 and $4,000. Exact pricing depends on footage, height, corners and downspouts.

Along each straight run, yes. Every wall gets one continuous piece of gutter. Joints remain only where they must: at inside and outside corners, at end caps, and where downspout outlets are cut in. Those points are riveted and sealed, and they are far fewer than the splices in a sectional system.

Well-installed seamless aluminum gutters commonly last 20 years or more. Lifespan depends on gauge, how well they are pitched and fastened, whether they are kept clear of debris, and hail exposure. Heavier .032-gauge aluminum and hidden hangers into sound fascia go a long way toward a long service life.

Most gutter repairs in San Antonio cost $150–$650 per visit. Resealing a couple of corners or replacing a few hangers is at the low end; re-pitching long runs, replacing downspouts or fixing several issues at once costs more. Fascia replacement is priced separately at about $8–$20 per linear foot, with typical jobs around $250–$1,200.

Yes. Most leaking seams, corners and end caps can be repaired by cleaning the joint to bare metal, re-riveting if loose, and applying fresh gutter sealant. If a sectional system leaks at many splices, replacing those runs with seamless gutter is often more cost-effective than resealing every joint again and again.

Gutters usually pull away because their fasteners have loosened or the fascia board behind them has rotted. Old spike-and-ferrule fasteners back out over time, and soft wood won’t hold any fastener. The fix is to replace rotted fascia, then rehang the gutter on hidden hangers screwed into solid wood about every 24 inches.

Replacing gutters on a single-story San Antonio home of about 2,000 sq ft typically costs $1,300–$2,600 in 5-inch seamless aluminum, and a two-story home $2,000–$4,000. That includes new gutters at $7–$15 per linear foot and removal of the old system at $1–$2 per foot. Fascia repairs and extra downspouts add to the total.

There is no fixed schedule. Seamless aluminum gutters that are well installed and maintained often last 20 years or more, while vinyl and older sectional systems tend to fail sooner. Replace when problems are widespread: leaks at many joints, sagging on several runs, chronic overflow, or major hail damage.

Yes. If one side of the house took the damage or has the failing runs, we can replace only those sections with seamless gutter. We match the profile and color as closely as possible. Keep in mind that new and older aluminum may weather slightly differently, so some homeowners choose to replace everything at once.

Most San Antonio homes pay $125–$275 for a single-story cleaning and $175–$375 for a two-story home. The price depends on total gutter length, roof height and pitch, the number of downspouts and how much debris has built up. Homes under heavy live oak or pecan cover land toward the top of each range, especially if downspouts or underground lines are clogged.

At least twice a year for most homes. If live oaks, pecans or Ashe juniper hang over your roof, plan on three or four cleanings a year. A good baseline is one cleaning in late spring after the live oak drop and another in late fall or early winter after pecans and other deciduous trees shed.

Live oaks shed most heavily in late winter and spring, roughly February through April, as new leaves push out the old ones. They also drop catkins, the stringy pollen tassels, during the same window. That is why late spring, not fall, is often the most important gutter cleaning of the year in San Antonio.

Professionally installed gutter guards in San Antonio typically cost $8–$25 per linear foot. Basic screens fall near $8–$12 per foot, and stainless steel micro-mesh usually runs $12–$25 per foot. For an average home with around 180 feet of gutter, that works out to roughly $1,440 to $4,500 depending on the product and roof.

Stainless steel micro-mesh is the best choice under live oaks. Its fine openings stop the small leaves, acorns and stringy spring catkins that clog screens and get tangled in brush and foam inserts. Expect to brush or rinse the top of the guard once or twice a year after the spring drop.

Only fine micro-mesh reliably keeps juniper needles out. Needles slide through standard screens, embed in foam and tangle in brush inserts, which creates clogs that are harder to clean than an open gutter. Under cedar, micro-mesh with occasional top-side cleaning is the setup we recommend.

Aim for at least 5 to 10 feet from the foundation, and farther if the yard slopes toward the house. On San Antonio’s expansive clay soils, water released right at the slab edge can contribute to foundation movement. Extensions, splash blocks on a downhill slope, or underground drain lines with pop-up emitters all help move water out of that zone.

Often, yes. 3x4 downspouts carry much more water and clog less, which matters during intense San Antonio downpours and under oak or pecan trees that drop acorns and husks. They are the standard pairing for 6-inch gutters and a smart upgrade for large roof planes, steep pitches and metal roofs.

In the San Antonio area, underground downspout drain lines typically cost $15–$35 per linear foot installed. The price depends on trench length, soil and rock conditions, how many walkways or irrigation lines must be crossed, and the type of discharge point, such as a pop-up emitter or curb outlet.

Fascia board replacement in San Antonio typically costs about $8–$20 per linear foot, and most jobs fall between $250 and $1,200. Price depends on how many feet are rotted, roof height, the material you choose and whether gutters must be removed and rehung. Small repairs at one corner sit at the low end.

Almost always because water is reaching it. Clogged gutters overflow onto the back of the board, leaking seams drip on the same spot, missing drip edge lets roof water run behind the gutter, and poor pitch leaves water standing. Fixing the water source is as important as replacing the wood.

Yes, if the fascia is soft or rotted. Gutter hangers need solid wood to hold. Hanging new gutters on rotted fascia leads to sagging and pull-away, sometimes within a single season. It is cheaper to replace boards while old gutters are already down than to remove new gutters later.

Copper gutters typically cost $28–$45 per linear foot installed in the San Antonio area, for either K-style or half-round profiles. Copper downspouts, soldered corners and decorative brackets add to that. A home with 150 feet of gutter can easily run several thousand dollars more in copper than in aluminum, so many owners use copper on the street-facing elevations only.

They work well when sized correctly, but a half-round gutter holds less water than a K-style gutter of the same width. On large or steep roof sections we often use 6" half-round, add an extra downspout, or use 4" round downspouts to keep up with San Antonio’s heavy downpours. The rounded bottom also sheds small debris slightly better.

You may. Exterior changes in San Antonio’s local historic districts can require review by the City of San Antonio Office of Historic Preservation, sometimes including a Certificate of Appropriateness. Requirements vary by property and scope, so confirm with the city before work starts. Changing the material or profile may be treated differently from like-for-like replacement.

Commercial box gutters and oversized 6"–8" systems typically cost $12–$30 per linear foot installed in the San Antonio area. Every job is quoted per project because lift access, building height, custom fabrication, scuppers and after-hours scheduling vary widely. Simple 6" seamless gutters on small commercial buildings can fall in the $9–$15 per linear foot range.

A box gutter is rectangular and is often custom-formed or built into the roof structure behind a parapet or between roof sections, so it can carry much more water. A regular K-style gutter hangs on the fascia and has a decorative front face. Box gutters are common on churches, older commercial buildings and multifamily properties.

Yes. After-hours and weekend scheduling is available for retail centers, offices and churches where daytime work would disrupt customers, members or services. Any premium for off-hours work is listed on the proposal so there are no surprises, and we coordinate access, lighting and parking-lot safety with your property contact.

Many homeowners policies cover sudden storm damage, including hail and wind damage to gutters, subject to your deductible. Coverage depends on your specific policy, including any cosmetic damage exclusions for metal components. Read your policy or ask your agent, document the damage promptly, and file the claim yourself with photos and a written estimate.

No. Texas law prohibits contractors from waiving or rebating your deductible. Offers to cover it, discount it through a fake rebate, or inflate an estimate to absorb it are illegal and can jeopardize your claim. A legitimate contractor will expect you to pay your deductible and will give you an honest, itemized estimate.

Small dents that do not affect flow, pitch or seams are usually cosmetic, and the gutter will keep working. Repair or replacement makes sense when dents hold water, seams crack, hangers bend, or downspouts are crushed. An inspection shows which dents are cosmetic and which are functional, which also helps your insurance discussion.